Skip to main content
TRACEFORMEmergency Electricians
Electric heating repairs

Storage Heater or Electric Heating Not Working? Same-Day Repair

Smoke, burning or scorching: leave and call 999. For a storage heater not working, a cold electric radiator, a tripping electric boiler or cold underfloor heating, we find the fault and aim to repair it the same day.

We test the heater and the circuit that feeds it, including the off-peak supply.

Call-out from£110weekday daytime · agreed before we travel · see prices

  • Same-day electric heating repair
  • Off-peak supply and timers tested
  • Repair priced before work starts
  • Under 60 minGreater Manchester
  • NICEIC registeredverified & trusted
  • Qualified & insuredfor your peace of mind
  • Local coverageGreater Manchester, Liverpool, London, Cambridge & Peterborough
Request a callback
TRACEFORM electrician checking a storage heater supply with a clamp meter as the homeowner watches in a living room
Heating back the same day where parts allowSupply, control and wiring faults are often put right on the first visit. A part for an older heater may need ordering.

What should you do when a storage heater is not working?

A storage heater not working is usually a supply, control or element fault. Check the input dial, the off-peak switch and the breaker, then call us. A weekday daytime call-out is typically £110–£150, agreed on the phone before we travel. We test the heater and its circuit and quote the repair before starting.

Manchester, Liverpool, Cambridge & Peterborough prices

Typical prices

Your call-out price is agreed on the phone before an engineer travels. Any repair is explained and priced for your approval before work starts.

  • NICEIC registered
  • Price agreed first

Emergency call-outs

First hour on site, including the call-out.

  • Weekday daytimeLowest price£110–£150
  • Weekday evening£150–£220
Do this first

When a storage heater is not working, the off-peak supply, timeswitch or meter is just as often to blame as the heater itself. We test each part in order and quote the electric heating repair before any work starts.

What to do first if your electric heating stops

If a heater is smoking, smells of burning or is scorched, keep away, get everyone out and call 999. Otherwise, these checks are safe:

  • Check the input dial or programme is set for heat and the output is not left high overnight.
  • Check the switches beside the heater are on. Storage heaters often have one for the off-peak supply and one for boost or fan.
  • If the consumer unit is dry and safe to reach, reset a tripped breaker or RCD once. If it trips again, leave it off and call us.
  • Do not cover or open the heater, and do not run borrowed heaters from extension leads.
Safety Notice

Do not open a heater, remove its panels or keep resetting a breaker that trips again. Smoke, burning or scorching means leave and call 999.

Still stuck? Call 07777 301818
Diagnostic view

Schematic illustration of how this fault is traced during diagnosis.

Signs your electric heating needs a repair

What each heating clue usually points to.

Storage heater cold in the morning even with the input turned upOften no off-peak supply, a timer fault or a tripped cut-out.
Storage heater hot overnight but cold before the eveningUsually the output setting or a sticking damper.
Electric radiator dead, or the display works but the panel stays coldTypically a controller, thermostat, element or fused spur.
Electric boiler tripping the RCD when it fires upCommonly an element breaking down or moisture inside.
Underfloor heating cold, showing an error or trippingOften a floor probe, thermostat or damaged mat.
Every heater stopped at once, often after a meter changeUsually the off-peak circuit, not every heater at once.
Describe what you are seeing

How a same-day electric heating repair works

From your call to a tested, working heater.

  1. Tell us what you have and what it is doing

    We ask which heaters are affected, their age, whether a breaker has tripped and whether the meter or tariff changed recently. A photo of the rating plate helps us bring likely parts. The call-out price is agreed before we travel.

  2. Check the supply before the heater

    We confirm the off-peak circuit is live when it should be and measure each heater's current draw with a clamp meter, which shows whether the fault is in the supply or the appliance.

  3. Isolate and test the appliance

    With the circuit isolated, we test elements for resistance and insulation breakdown and check the cut-out, thermostat, damper, fan and connections.

  4. Quote and repair

    You get a clear price first. Where parts allow, the repair is done on the same visit. If a part for an older heater has to be ordered, we make it safe and book the return.

  5. Test and hand back

    We test continuity of protective conductors, insulation resistance, polarity, earth fault loop impedance and RCD trip times, then give you the paperwork the job needs.

Right now

Which heater, which fault?

Each type of electric heater fails in its own way.

Which heater, which fault?
HeaterCommon faultWhat we test first
Storage heater cold in the morningNo off-peak supply, failed element or tripped cut-outOff-peak circuit and timer during the charge period, then element resistance.
Storage heater hot all night but cold by eveningOutput left high, damper not closing or fan faultControl settings, then the damper and fan controls.
Electric radiator dead or not heatingNo supply, thermostat, controller or element failureFused spur and supply, then element continuity and controls.
Electric boiler tripping the RCDElement insulation breaking down or moisture insideInsulation resistance of each element, with the boiler isolated.
Underfloor heating cold or trippingThermostat, floor probe or damaged heating cableProbe resistance, then mat resistance and insulation resistance.

All heaters cold together points to the supply. One cold heater points to that heater.

Sources: Electric storage heaters (Energy Saving Trust)

Storage heater not charging overnight: the usual causes

A storage heater only charges while its off-peak circuit is on overnight. If every heater is cold at breakfast, suspect the supply: a timeswitch that lost its settings in a power cut, a failed meter switching contact, or an off-peak circuit not reconnected after a meter exchange. Older radio-controlled meters are being phased out, and heaters on them can stop charging until your supplier replaces the meter.

If one heater is cold and the rest are warm, the fault is usually inside it: a failed element, a tripped thermal cut-out, a faulty input thermostat or a burnt terminal. We confirm which with a clamp meter during the charging period.

Hot all night but cold by the evening

Heat is escaping too early. An output dial left high, a damper that no longer closes or a fan running at night will empty the core. Turn the output to minimum before bed; if it still runs out, we check the damper and fan.

Electric radiator not working

A blank display usually means no supply, so we check the fused spur, wiring and the radiator's own fuse. A working display with a cold panel points to the element, thermostat, controller or an internal cut-out.

Electric boiler tripping RCD or not firing

An electric flow boiler heats water with elements switched by contactors. If the RCD trips as it fires, an element's insulation is usually breaking down, or moisture has got inside, so we test each element's insulation resistance. A boiler that never heats may have a failed contactor, a tripped overheat thermostat or a dead element. Leaks, low pressure or pump faults are for a heating engineer or plumber.

Electric underfloor heating not working

A cold floor is most often the thermostat or floor probe, and both can usually be replaced from the wall. If the heating trips the RCD, the cable may be damaged by a fixing, drill or tiling work. We measure element and insulation resistance against the manufacturer's figures and explain the options before anything is lifted.

Storage heater repair or replacement?

Elements, thermostats, cut-outs, dampers and fans can be replaced on most heaters, so repair is often sensible. Replacement makes sense when parts are no longer made or the casing is damaged. Heaters installed before 1974 may contain asbestos; we will not dismantle those, and a specialist must remove them.

What the official guidance says

Why people call us when the heating fails

We test the supply and the heater, so the repair fixes the real fault.

Same-day repairs

Typically with you within 60 minutes in Greater Manchester, Liverpool, Cambridge and Peterborough, and within 2 hours in London.

Supply and appliance tested

We check the off-peak circuit and wiring as well as the heater, so parts are not fitted to fix a supply fault.

Prices agreed first

Call-out agreed on the phone, repair quoted on the spot before work begins.

Tested before we leave

Every repaired circuit is tested.

Every type of electric heating

Storage heaters, electric radiators, flow boilers and underfloor heating.

Off-peak switching checked

Timeswitches, two-rate meter switching and the off-peak circuit.

Safe isolation first

Faulty heaters are isolated so the rest of the home stays on.

Electric heating repairs for homes, rentals and businesses

All-electric homes, rented flats and shared buildings.

Off-peak and tripping guides

Hot water, overnight trips and breakers that will not stay on.

Electric heating repair questions

Answers to what people ask when electric heating stops.

Why is my storage heater cold in the morning when the input is on high?
It is probably not getting its off-peak supply, or a part inside has failed. If several heaters are cold, suspect the timeswitch or meter switching. If only one is, it is usually the element, thermal cut-out or input thermostat.
How much does an electric heating repair cost?
A weekday daytime call-out is typically £110–£150, agreed before we travel. A simple fault such as a timer or loose connection is typically £110–£185; an element or off-peak circuit fault is typically £155–£255. You get the exact price before work starts. The figure depends on when you call, the fault (a timer or connection is quicker than an element or controller), whether parts are in stock or discontinued, and how many heaters or the off-peak circuit are involved.
Can you repair a storage heater the same day?
In most cases, yes. Supply, timer and wiring faults are often put right on the first visit, and common parts can often be sourced the same day. Parts for discontinued heaters may need ordering, so we make the heater safe and return.
My heaters stopped after a new meter was fitted. Why?
After a meter exchange the off-peak circuit may not have been reconnected, or the switching times may have changed. Ask your supplier to confirm your off-peak times, and we can test the circuit to show where the supply stops.
Is it safe to keep resetting an electric boiler that trips the RCD?
No. One reset is fine, but a repeat trip means current is leaking to earth, often from an element or water inside. Leave it off and have the elements tested.
Can underfloor heating be fixed without lifting the floor?
Often, yes. Thermostats and floor probes fail most and are replaced from the wall. If the cable is damaged, we test it and explain the options before any tile is lifted.
Who fixes the storage heaters in a rented flat?
The landlord, as heating is a repair they must carry out. Tell your landlord or agent in writing; they can book us directly. We arrange access with the tenant, and if someone elderly, very young or unwell is without heat, tell us so we can prioritise the visit.

Secure callback request

Request a callout

Share your details and an electrician will call you back. Typical response under 60 minutes.

  1. 1 · The problem
  2. 2 · Your details

Step 1 of 2: the problem

What do you need help with?
How urgent is it?
Photos of the problemoptional · up to 5

A photo of the fuse box or fault helps us bring the right parts. Location data is removed.

  • NICEIC
  • 24/7
  • Clear prices

Your details are only used to respond to your enquiry

Greater Manchester coverage

Check your area

Enter a full UK postcode to confirm we cover your area and can respond quickly.

  • Greater Manchester, Liverpool, London, Cambridge & Peterborough
  • Surrounding areas
24/7 emergency electricians

Electric heating gone cold?

Tell us which heaters are affected. We agree the call-out, find the fault, quote the repair and aim to have the heat back the same day.