Skip to main content
TRACEFORMEmergency Electricians
Outdoor and outbuilding faults

Outdoor Socket Keeps Tripping? Garden, Garage and Shed Repairs

If anything outside is smoking or melted, keep away and call 999. When an outdoor socket keeps tripping, leave it off rather than resetting it. We trace the fault, repair it and test it before we leave.

Most outdoor faults come from water getting in or a damaged cable, and testing tells us which.

Call-out from£110weekday daytime · agreed before we travel · see prices

  • Sockets, lights, garages and sheds
  • Buried cable faults traced
  • Repair priced before work starts
  • Tested before we leave
  • Under 60 minGreater Manchester
  • NICEIC registeredverified & trusted
  • Qualified & insuredfor your peace of mind
  • Local coverageGreater Manchester, Liverpool, London, Cambridge & Peterborough
Request a callback
TRACEFORM electrician testing a weatherproof outdoor socket on the brick wall of a house as the homeowner watches
Outside circuits fail for outside reasonsRain, frost, spades, fence posts and rodents cause most outdoor faults. We test each part of the run until the damaged section is found.

Why does my outdoor socket keep tripping?

An outdoor socket keeps tripping because the RCD has detected current leaking to earth, usually from water in the socket, a damaged buried cable or faulty equipment. Leave it off and keep away if it is wet. A weekday daytime call-out is typically £110–£150, agreed before we travel.

Manchester, Liverpool, Cambridge & Peterborough prices

Typical prices

Your call-out price is agreed on the phone before an engineer travels. Any repair is explained and priced for your approval before work starts.

  • NICEIC registered
  • Price agreed first

Emergency call-outs

First hour on site, including the call-out.

  • Weekday daytimeLowest price£110–£150
  • Weekday evening£150–£220
Do this first

An outdoor socket that keeps tripping, an outside socket not working, garden lights gone dark or a garage that loses power when it rains all point to a fault on the outdoor run. The cause is usually physical: water in an accessory, a corroded joint or a nicked buried cable. Our outdoor electrical repairs start with testing, so the failed part is found rather than guessed at.

What to do first when an outdoor socket trips

  • Smoke, flames or melting outside: keep everyone away and call 999.
  • If someone has had a shock, do not touch them. Switch off at the consumer unit only if it is safe to reach, then call 999.
  • Leave the tripped switch off. Repeated resets keep feeding the fault.
  • Do not go out to the socket, lights or garage in the rain, and do not touch anything wet or damaged.
Safety Notice

Do not touch a wet, cracked or damaged outdoor socket, light or cable, and do not go out to it in the rain. For smoke or flames, leave and call 999.

Still stuck? Call 07777 301818
Diagnostic view

Schematic illustration of how this fault is traced during diagnosis.

Signs your outdoor circuit has a fault

What each outdoor warning sign usually points to.

The outdoor socket trips the RCD when something is plugged inFaulty equipment or water in the socket.
Power goes off after heavy rain or frost, then returns once dryWater is reaching a socket, joint or cable.
An outside socket not working, with nothing trippedA broken connection or failed accessory.
Garden lights not working along the whole run, or only someAll out: transformer. Some out: a joint or lamp.
The garage or shed board trips, or the house trips with itLeakage on the outbuilding supply.
A cracked lid, missing seal, scorch mark or water inside the socketThe enclosure has failed and needs replacing.
Describe what you are seeing

Why an outdoor socket keeps tripping

The RCD switches off when it detects current leaking to earth, and outside that leak is nearly always physical. Water is the usual cause: a lid left open, a perished seal, a cable entering from the top of the box, or a dripping hosepipe tap beside the socket. That is why the trips often follow heavy rain and stop once things dry out.

Next comes cable damage. Buried runs get hit by spades, fence posts and edging tools, and rodents chew cable in garages. Then there is equipment: a mower, pond pump or pressure washer with water in the motor, or an indoor extension lead left on wet grass, will trip a healthy circuit.

Outside socket not working but nothing has tripped

A dead socket with every switch still on usually means a broken connection, not leakage. Corroded terminals, a blown fuse in an indoor spur, a switch someone has turned off or burnt socket contacts can all cut the supply. We work back from the socket to the source until the break is found.

Garden lights not working: transformer, connectors or cable

Low-voltage garden lighting runs from a transformer. If every light goes out and nothing trips, the transformer or timer is the usual cause; if only part of the run fails, the fault is usually in a connector or joint. Mains-voltage spike lights and bollards are wired like any other circuit, and water in one fitting can trip the whole lot. We test each light and joint so only the faulty one is replaced.

Garage electrics keep tripping or shed electrics not working

Garages and sheds are usually fed by a cable from the house, often armoured, with a small consumer unit at the far end. When the house and garage boards both have 30 mA RCDs, one fault can trip either, so it looks like a house problem. Freezers and old tools are common culprits. When shed electrics stop working altogether, we test the supply cable and the outbuilding circuits separately to show whether the fault is in the ground or the building.

What we test on an outdoor circuit

  • Insulation resistance, whole run then section by section
  • Continuity of protective conductors, including the cable armour
  • Polarity at sockets, switches and fittings
  • Earth fault loop impedance
  • RCD trip time
  • The buried cable route, traced with a locator

Outdoor electrical repairs we carry out

A water-damaged socket is replaced with a weatherproof accessory, typically IP66 where it faces driving rain or a pressure washer, with the cable entering from below. A damaged buried cable is exposed by hand once traced, then re-jointed with a sealed kit or replaced in a short section. Where the garden shares an RCD with half the house, we may suggest moving it onto its own RCBO, priced separately and fitted only if you agree.

When a repair turns into planned work

Sometimes testing shows the outdoor wiring was never suitable, such as indoor cable buried without protection or a garage fed from an extension lead. We make it safe on the night, then quote new outdoor points and garden lights through our sockets and lighting service, or a new outbuilding supply through our new circuits service.

How we repair an outdoor electrical fault

From the first call to a repaired, retested outdoor circuit.

  1. Tell us what happened

    We ask what trips, when it started, what was plugged in and whether it has been wet. The call-out price is agreed before we travel.

  2. Isolate and inspect

    We isolate the outdoor circuit, prove it dead and open the socket, light fittings or garage board, looking for water, corrosion, failed seals and loose terminations.

  3. Test until the fault is found

    Insulation resistance is tested on the whole run, then section by section, so a damp socket is told apart from a damaged buried cable. Hidden routes are traced with a cable locator before anyone digs.

  4. Price, repair and retest

    The repair is priced on the spot before work starts and, where parts allow, done on the same visit. We then retest the circuit, explain the results and give you the paperwork the job needs.

What the safety bodies say about outdoor electrics

Why people call us for outdoor faults

Outdoor faults hide in wet ground and sealed boxes. Testing finds them.

Tested, not guessed

We test each section of the run, so only the part that failed is replaced.

Water ingress understood

We check IP ratings, seals and cable entries, then fit an accessory suited to the position.

Buried cables located first

Routes under lawns and paths are traced before digging, keeping the repair small.

24/7, any season

Typically with you in under 60 minutes in Greater Manchester, Liverpool, Cambridge and Peterborough, and under 2 hours in London.

Outdoor sockets

Weatherproof sockets that trip, are dead or have water inside.

Garden lighting

Transformers, connectors and fittings on existing garden circuits.

Garages and sheds

Supply cables, small consumer units, sockets and lights.

Outdoor socket and garden electrics questions

Answers about outdoor sockets, garden lights, garages and sheds.

Why does my outside socket trip every time it rains?
Rain is reaching a live part, usually through an open lid, a perished seal or a top cable entry. It can also be a damaged buried cable that leaks once the ground is wet. Leave it off and have it tested.
Is it safe to keep resetting a tripping outdoor socket?
No. Each reset puts power back into whatever has failed, which outdoors may be a wet socket or exposed cable. Leave it off and tell us what was plugged in when it tripped.
How much does it cost to repair an outdoor socket?
A weekday daytime call-out is typically £110–£150. A simple fault such as a water-damaged socket is typically £110–£185, and a buried cable or outbuilding board fault typically £155–£255, priced on the spot before work starts. A water-damaged socket near the house sits at the lower end; long buried runs, cables under patios and outbuilding boards take longer to trace.
My garden lights have stopped working but nothing has tripped. What is wrong?
With every low-voltage light out, the transformer or timer is the usual cause. If only some are out, the fault is usually a connector, joint or single fitting.
Can you find a fault in a cable buried under the lawn?
Yes. Insulation resistance testing confirms the damage, a cable locator traces the route, and only the damaged section is dug out and repaired.
Why does the house trip when I use power in the garage?
The garage is often protected by the house RCD as well as its own, so a fault on a freezer, tool or the garage wiring can trip the house first. We test both and can arrange the protection so a garage fault stays in the garage.

Secure callback request

Request a callout

Share your details and an electrician will call you back. Typical response under 60 minutes.

  1. 1 · The problem
  2. 2 · Your details

Step 1 of 2: the problem

What do you need help with?
How urgent is it?
Photos of the problemoptional · up to 5

A photo of the fuse box or fault helps us bring the right parts. Location data is removed.

  • NICEIC
  • 24/7
  • Clear prices

Your details are only used to respond to your enquiry

Greater Manchester coverage

Check your area

Enter a full UK postcode to confirm we cover your area and can respond quickly.

  • Greater Manchester, Liverpool, London, Cambridge & Peterborough
  • Surrounding areas
24/7 emergency electricians

Outdoor socket, garden lights or garage tripping?

Leave it off and keep away from anything wet. We trace the fault, price the repair first and test before we leave.